We often use various lamps and lanterns in our daily life. The wiring methods of different lamps and lanterns are also different. How to connect LED light strips?

1、 How to connect the LED light strip

1. Welding method

First, make sure whether the lamp uses high voltage or low voltage power. Normally, considering the product nature, the lamp strip will be equipped with low voltage power. Then select the required LED lamp strip. Then check two dots in every three lamp beads on the lamp strip and weld the line to the dot.

2. Terminal connection

First, connect all the lamp beads in parallel with many resistors. This type of lamp strip should be equipped with 12V DC power. Connect the two output lines of the DC power supply to the corresponding positive and negative line ports of the lamp strip, and then plug the power line into the socket. However, the 12V battery pack can also be directly used for power supply.

3. Driver wiring method

Connect the lamp beads of the lamp strip in series, and then equip it with a driver. Insert the two pins of the driver plug into the core of the two leads of the lamp strip according to the appropriate polarity, and then plug the power plug of the driver into the 220 volt power socket at home.

2、 What is the way to purchase LED light strip

There are many categories of LED light strips on the market. In order to buy products that meet our own needs, we should also master the corresponding skills when we actually purchase. The following are some points for attention when purchasing.

1. The LED light strip uses the patch technology, so the welding points are relatively lubricated, while the surface of the defective LED light strip welding points is unevenly distributed.

2. The surface of the LED light strip is neat and clean, and there will be no significant stains. However the outer layer of the defective light strip is cleaned, there will be more or less stains

Article Source:Cord lamp manufacturerhttps://www.hs-hongshun.com/